Technical Characteristics of Halogen Underwater Light
Point the projector away from the house or terrace, so as not to create an excessively bright illumination.
The projector should not be positioned more than 60cm under the coping, as measured from the center of the bulb. The projector’s niche incorporates two ¾” outlets. The rear outlet is generally used for masonry swimming pools, while the vertical outlet is primarily intended for swimming pools built from panels.
Liner Masonry Structure:
Fit the site protection on the front of the niche.
Seal the projector’s niche into the masonry, making sure that you position it the right way up. Fit the plug in the unused outlet. Take necessary stops to ensure that you can subsequently apply rendering around the front panel.
Fit the seal on the front panel of the projector’s niche.
Secure the sealing flange after installing the liner.
Cut the liner
Liner Panels Structure
Use the template for cutting the panel. Install the projector’s niche from within the basin. Screw it onto the panel after fitting the foam in position, positioning the lighting unit securing striae horizontally.
Proceed with sealing the liner, flexible conduit and cable, and install the lighting unit of the projector identical to the liner projector.
Masonry Structure without liner
Seal the niche of the projector into the masonry, the front part should be recessed, so that finishing rendering or tiling can be applied subsequently.
Proceed with sealing the flexible conduit and cable, and install the lighting unit of the projector in the same way for the vinyl light.
Installation of Incandescent Underwater light
- Push the projector’s lighting unit cable through the cable gland.
- Thread the cable of the projector’s lighting unit through the flexible conduit up to the connection box.
- Seal the cable gland around the cable.
- Place the lens in front of its housing, rolling up any extra cable.
- Fit the projector’s lighting unit into the niche, positioning the claws within the striae.
Underwater Light Maintenance
Original components must be used in all replacement operations.
When changing a bulb and/or cable, it is recommended that all components be changed to avoid compromising the seals. Type of light used: PAR 56, in the event of necessity changing of the light, to use original part.
